wake-panellisted
Install: claude install-skill REMvisual/claude-wol-remote-access
# Wake Panel
Build a password-protected web panel, hosted on an always-on device, that wakes
and monitors the user's computers from anywhere on their tailnet.
## The one fact that drives the whole design
**A Wake-on-LAN magic packet is a layer-2 broadcast. Tailscale is layer 3 and
forwards no broadcast traffic.** A phone off the home LAN therefore cannot wake
anything directly — not with Moonlight's "Wake PC", not with any WoL app, not
through a Tailscale subnet router. This is not a limitation to engineer around;
it is how WoL works.
So the packet must originate on the LAN. An always-on device hosts a relay:
```
phone (anywhere) --Tailscale--> relay host --LAN broadcast--> target PC
```
The relay must NOT live on one of the machines being controlled — a PC cannot
wake itself, and two PCs that are both off cannot wake each other.
## Running this
Work through the stages in order. **Each stage ends with a gate — do not
proceed past a failed gate.** Later stages assume earlier ones actually worked,
and a silent failure at stage 3 surfaces as an inexplicable one at stage 6.
Do as much as possible yourself over SSH. Hand the user a command ONLY when it
needs local elevation, physical access, or a password you must not see.
Read `reference/TROUBLESHOOTING.md` when anything fails. Nearly every failure in
this domain has a specific, non-obvious cause already catalogued there.
### Stage 0 — Preflight
Establish and confirm with the user:
| Need | Why |
|---|---|
| An alway