twincat-scopelisted
Install: claude install-skill SionVerhoef/twincat-scope
# twincat-scope — measure a machine, then actually read the measurement
> **Reference material only. Not for safety functions.** Every scope configuration, recording
> plan and diagnosis you produce must be reviewed and validated by a qualified engineer
> against the drive and platform documentation before anyone acts on it.
Recording is the easy half. Ten minutes of twenty channels at 1 kHz is twelve million
samples — far too large to read, and the thing you are looking for is usually three samples
wide. So this skill never hands back samples: it hands back summaries, events and pictures,
and only returns real rows once a time range is known.
**Not for authoring code.** This skill measures and diagnoses. Once the data has named a
fault, writing the PLC fix is a different job. Load the companion skill `twincat-st` for it if
it is installed; otherwise hand off to whatever covers ST authoring in this project.
## The four rules
1. **No safety logic.** This skill writes no code, safety code least of all; reading, explaining
and recording safety signals is fine.
2. **Never write to or activate a live machine.** Reading measurements is safe. Writing a
variable, activating a configuration, or switching Run/Config mode is a human gesture —
propose the command, do not run it.
3. **Never claim something is verified that you have not verified.** There may be no TwinCAT
installation on this machine. What has and has not been seen working in TwinCAT
is under *Status* b