← ClaudeAtlas

audio-interface-digital-iolisted

Use when advising on audio interfaces, digital I/O (ADAT, S/PDIF, MADI), clocking and mixers, incl. RME Digiface USB and Ferrofish Pulse 16, on Linux.
SpeakingColors/claude-skills · ★ 0 · Code & Development · score 72
Install: claude install-skill SpeakingColors/claude-skills
# Audio interfaces and digital I/O (music production on Linux) Labels: VERIFIED (source) = read this session in the cited source. COMMUNITY = forum/user report or widely repeated engineering knowledge not re-checked here. UNVERIFIED = could not confirm; treat as open question. Do not upgrade a label without a new source. ## 1. Analog connections and levels - XLR: balanced, 3-pin, mic or line. TRS 6.3 mm: balanced line (or stereo/headphone). TS 6.3 mm: unbalanced mono (instrument, synth). COMMUNITY. - Mic level (tens of mV, needs preamp gain) vs line level (about 1 V) vs instrument/Hi-Z (high impedance, guitar/bass DI). COMMUNITY. - Pro line reference +4 dBu (1.228 V RMS); consumer -10 dBV (0.316 V RMS). The two differ by about 11.8 dB. COMMUNITY. - Hardware synths into converters: match the converter's reference level; a too-hot synth clips the AD, a too-quiet one wastes bits. COMMUNITY. - Balanced cables reject hum; use TRS/XLR between balanced gear, TS only for short unbalanced runs. COMMUNITY. ## 2. Digital formats - AES/EBU (AES3): 2 ch, balanced XLR 110 ohm, pro level. COMMUNITY. - S/PDIF: 2 ch, coax (RCA, 75 ohm) or optical (TOSLINK). Consumer framing; same audio as AES3 in practice. COMMUNITY. - S/PDIF is not rate-limited like ADAT: a Digiface USB S/PDIF output supports 192 kHz (RME staff, forum). VERIFIED (https://forum.rme-audio.de/viewtopic.php?pid=248243). - ADAT (lightpipe): optical TOSLINK, 8 ch at 44.1/48 kHz. COMMUNITY (consistent with RME and Ferrofish page