← ClaudeAtlas

eda-engineerlisted

Design, simulate and check small electronic circuits with the ai-eda CLI (AI EDA Engineer): KiCad schematic and PCB, ngspice simulation, ERC/DRC, BOM/CPL, an independent review with evidence. Use when the user asks things like "design this circuit", "회로 설계해 줘", "make a KiCad project", "run ERC / DRC on it", "simulate it in SPICE", "give me the BOM", "ai-eda로 만들어 줘", "voltage divider / LED resistor / RC or LC filter / I2C pull-ups / BJT switch / astable / ATmega128 board". Not for general KiCad usage questions, writing or explaining SPICE decks by hand, or pure firmware questions.
Yuchan-00/EDA_Engineer_Skill · ★ 0 · AI & Automation · score 65
Install: claude install-skill Yuchan-00/EDA_Engineer_Skill
# EDA Engineer (ai-eda) Verification-first circuit design: every number has a provenance, every verdict comes from a tool, "we could not check" is its own status. The agent drives the `ai-eda` CLI; it never edits `ir.json` by hand. ## Hard limits (read these first) - Circuits come only from 13 built-in templates (8 generic, 5 KR 447 MHz radio boards). A request no template covers is refused (`no template matches the confirmed requirements (templates: ...)`); a template also refuses an input outside its bounds, an unserved requirement (`leave_out` remedy) or two matching templates (`ambiguous`). Every refusal is correct: do not work around it. - Parts without a SPICE model (the ATmega128 MCU, the L7805 regulator, connectors) are `exclude`d from the netlist by their template; a requirement they serve is verified only when an ideal stimulus stands in (`verified with <ref> excluded: <reason>`). The part itself is never simulated: firmware never runs, nothing claims an MCU works. - Offline (the default), datasheets and regulations are never fetched (copies archived by an earlier `--online` run are still read), so part existence and regulatory sources stay NOT_VERIFIED and RELEASE never reaches `evidence-backed release`; `regulatory.compliance` is NEVER assessed by this system. - ERC/DRC need `kicad-cli` (KiCad 10+); SPICE needs a shared ngspice library (KiCad's bundled one, `NGSPICE_DLL`, or a system libngspice; an AM source needs ngspice 43+). Without them th