genlayer-clilisted

# GenLayer CLI The `genlayer` CLI manages contract deployment, interaction, transaction inspection, and network configuration. Works with GenLayer Studio (local), studio.genlayer.com, and Testnet Bradbury. ## Setup ```bash npm install -g genlayer ``` ## Network Configuration ```bash genlayer network set # Interactive selector genlayer network set testnet-bradbury # Direct genlayer network info # Show current network config genlayer network list # List all networks ``` Networks: `localnet`, `studionet`, `testnet-asimov`, `testnet-bradbury` **Note**: `studionet` is gasless — no tokens are required to deploy or interact with contracts. A 0 GEN balance is expected and does not prevent any operations. **Note**: `studionet` is rate-limited per IP — **60 req/min, 1000 req/hr, 10000 req/day**. Limits aren't permanent — batching many `deploy`/`write` calls trips `-32429` / HTTP 429 and further requests are rejected until the window resets (next minute / hour / day cycle). `-32028` signals the pending-queue cap — **up to 32 in-flight txs per sender**; a separate cap also applies per contract. Throttle batch scripts, wait for receipts between submissions, or use `localnet` for heavy batches. **Always use `genlayer network set` instead of `--rpc`** for built-in networks. The `--rpc` flag bypasses the chain configuration (consensus contract ABI, `isStudio` flag, etc.) and will cause transaction polling failures. Only use `-