installlisted

# Install cosmobar Install the cosmobar status line and walk the user through setup. cosmobar is a single static Go binary (macOS/Linux). Follow these steps in order. ## Steps 1. **Check whether it's already installed.** Run `command -v cosmobar`. - If found: tell the user cosmobar is already installed, run `cosmobar upgrade --check` to report whether a newer release exists, and skip to step 5 (offer to configure). Do **not** re-download. 2. **Install the binary.** Run the official installer: ``` curl -sS https://raw.githubusercontent.com/oleksbard/cosmobar/main/install.sh | sh ``` The user will see the normal Bash permission prompt for this command — that is expected and intentional. Show the installer's output. If the download fails (network error, non-zero exit), report the failure and give the user the same `curl … | sh` command to run themselves, then stop. 3. **Verify the install.** Run `cosmobar --version`. - If it prints a version, continue. - If it reports "command not found", the binary was installed to `~/.local/bin`, which is not on the user's `PATH`. Tell the user to add it (`export PATH="$HOME/.local/bin:$PATH"` in their shell profile) and, for the next step, use the full path `~/.local/bin/cosmobar`. 4. **Initialize.** Run `cosmobar init` (or `~/.local/bin/cosmobar init` if it wasn't on `PATH`). This wires `~/.claude/settings.json`, writes a default config to `~/.config/cosmobar/config.toml`, and installs the `/cosmobar` guided-setup