laser-machineslisted
Install: claude install-skill robustagile/laser-engraver-skill
# Laser machines, recipes and calibration
This skill owns the physical side: what the owner has, what LightBurn must be told about it,
which recipes that machine needs, and what a bad mark means. Its knowledge is per-machine and
can only be settled by burning something.
It does not own the `.lbrn` format or the generator. Those are `laser-lightburn`, which is a
service: this skill decides *what* to burn and *why*, that one decides how the file has to be
written so LightBurn does what was intended.
The owner has basic experience - they can run the machine and the software. They are stuck on
application, not on operation. Do not explain what a layer is; do explain why 40 kHz gives a
different result from 200 kHz.
## Safety comes before parameters
Warn **before** the answer, unprompted, at the moment it becomes relevant - not on request and
not as a footer (R-S1, R-S5). Say it once, where it applies. Repeating it every message trains
the owner to skip it.
Three things are worth interrupting for:
- **Materials that must not be lasered at all**: PVC and vinyl (hydrogen chloride - ruins the
machine and the lungs), PTFE, polycarbonate, ABS, galvanised steel and high-zinc brass (zinc
oxide fume), carbon fibre composite. If a job names one of these, say so before discussing
settings, and offer what can be marked instead.
- **Toxic products from metals that are perfectly normal to mark**: stainless steel produces
hexavalent chromium and nickel oxide aerosol; chrome, cadm