sticky-devicelisted
Install: claude install-skill varo6/reTerminal-sticky-skill
# reTerminal Sticky
Seeed Studio reTerminal Sticky: a magnetic ESP32-S3 e-ink note device. 3.97" 800x480
monochrome ePaper with 4-level grayscale, capacitive touch, 750 mAh battery.
Firmware is native **ESP-IDF v5.4 / target `esp32s3`** (C/C++). ESPHome is the
supported no-C path. Apps are distributed by flashing whole firmware images — there
is no on-device app sandbox or multi-app runtime.
## Read this first for any firmware task
Two rules cause most first-time failures on this device:
1. **Latch power on at boot.** The device powers off unless firmware drives the
power-hold GPIOs within the first moments of `app_main()`. See
[references/esp-idf-dev.md](references/esp-idf-dev.md).
2. **The panel is natively 800x480 landscape.** Your logical canvas orientation is a
choice you implement with a rotation in the pixel-write path. Pick one and keep
touch coordinates in the same space. See [references/display.md](references/display.md).
## Where to look
| Task | File |
|---|---|
| Pin map, buses, part numbers, electrical/physical specs | [references/hardware.md](references/hardware.md) |
| Toolchain, project skeleton, `sdkconfig.defaults`, build/flash, power latch, NVS, deep sleep | [references/esp-idf-dev.md](references/esp-idf-dev.md) |
| ePaper driver API, refresh modes, rotation, ghosting, partial-update strategy | [references/display.md](references/display.md) |
| Touch/GT911 gestures, buttons, IMU, SHT40, RTC, mic, buzzer, fuel gauge, SD | [references/peri