dayz-p3d-auditlisted
Install: claude install-skill willy92wins/DayZ-Modding-Knowledge-Pack
# DayZ P3D Audit — Complete Model & Mod Validator
Validates .p3d model files, config.cpp, model.cfg, and .rvmat materials against
DayZ engine requirements. Built from production debugging where models rendered
correctly but had zero collision, missing animations, or broken textures.
## Preflight gate
Per the L2 rule (`_shared/dayz-conventions.md`), every DayZ skill that does work gates on `/dayz-preflight` first. The audit reads `.p3d` files which can live anywhere, but the moment you point it at `P:\` paths or a built mod, an unmounted P-drive silently produces wrong results. Run `/dayz-preflight` before this skill.
## The three py3d gates cannot go red for geometry (SP-227-py3d-gates-cannot-go-red)
A clean `validate()`, a passing `save(verify=True)`, or a `diff` that reports equal is not evidence that the geometry is correct. Those checks only prove internal count consistency. When declaring a model verified, say whether vertex order was compared against debinarized vanilla or whether it was tested in-game.
1. `validate()` does not detect GLOBAL winding inversion. The winding check is relative to the Visual LOD. If every LOD is inverted (Blender Z-up to Y-up; this skill, PART 5 item 1), `validate()` returns an empty list and exit 0. If only Visual is inverted, it accuses healthy collision LODs (`ERR_WINDING_INVERTED`). The message of `py3d_dayz-1.8.0`, the wheel pinned until 2026-10-02, tells you to run `face.vertices.reverse()` on every face of each one (it warns aga