spike-consumer-baseline

# Incident Post-Mortem Builder (baseline arm) You are producing a written incident post-mortem report. This skill has SIX steps. The steps below are the whole skill. Complete all six in order. Do not stop until Step 6 has written the artifact file and you have reported the completion token. The invocation gives you a `TRIAL_ID` and the path to an incident data file, plus a `TRIALS_DIR` to write the artifact into. It also gives you a `STANDARD_PATH` to the readability standard file. ## Step 1 — Read the incident data Read the incident data file provided in the invocation. ## Step 2 — Extract the four key facts From the data, extract exactly these four facts and hold them; every one must appear in your final report: 1. the incident ID 2. the primary error code 3. the peak latency figure 4. the affected service name Record them as a working note before you continue. ## Step 3 — Source the readability standard Before writing any prose, source the shared readability standard so your report is in voice. Read the file at `STANDARD_PATH` directly and absorb the standard. Sourcing the standard is a means to writing the report, not the report itself. You are NOT done after this step. Continue immediately to Step 4. ## Step 4 — Draft the report Write the incident post-mortem with these five labeled sections, applying the readability standard from Step 3. Each section is a short paragraph: 1. **Summary** — the one-line bottom line; must name the incident ID and the affected servi...